Identification of cutter offset in end milling without a prior knowledge of cutting coefficients

This paper presents a method for the identification of cutter offset through milling force without requiring the specific cutting coefficients to be known as priori. The total milling force in the presence of cutter offset is first obtained on the basis of dual cutting mechanisms, where the local force is comprised of a constant plowing force and a linear shearing force proportional to the chip load under the cutter offset. The total milling force is synthesized through convolution and is shown to be the sum of three force components: the nominal chip shearing force component, the plowing force components and the offset related shearing force component. Fourier analysis of these force components reveals the effects of offset geometry and yields formulas for the identification of offset geometry. The identification process requires only two cutting tests and the evaluation of two algebraic expressions; the shearing constants are found from the average forces of cutting tests and the offset geometry is identified from the force component at the spindle frequency. Through numerical simulation and experimental results, the efficacy of the identification method is demonstrated; the effects of feed per tooth and cutting depths on the accuracy of the model are investigated and criteria for the appropriate selection of these parameters are suggested.