3-D temperature and stress distributions of strip in preheating furnace of continuous annealing line

Tei-Chen Chen, Chang Hsien Ho, Jia Ching Lin, Li Wen Wu

研究成果: Article

16 引文 斯高帕斯(Scopus)

摘要

The cold-rolled steel sheets produced by continuous annealing line (CAL) exhibit a significant phenomenon of warping during punching process. The phenomenon of warping is attributed to the non-uniform residual stress of steel strip, which may result from the non-uniform distributions of the temperature and plastic deformation along both the width and thickness of strip when it passes through the rolls in the CAL. In this study, only the distributions of the temperature and thermal stresses of strip in the preheating zone, one of several zones in CAL, are investigated first. Both the thermal and mechanical analyses are performed by using the finite element code ANSYS to investigate the effects of heating conditions in the preheating furnace. The equivalent emission of radiation of the strip corresponding to the complicated furnace environment is evaluated inversely with the aid of strip temperature estimated by energy balance model. Moreover, three-dimensional (3-D) distributions of the temperature and deformation of strip are then iteratively evaluated by the energy and mechanical models due to their coupling effect until a satisfied convergence in numerical solutions is obtained. The results show that the taper rolls tend to introduce a significantly non-uniform distribution of the temperature along the width. This temperature pattern might lead to an unfavorable consequence of enormously non-uniform distribution of stress along the width.

原文English
頁(從 - 到)1047-1057
頁數11
期刊Applied Thermal Engineering
30
發行號8-9
DOIs
出版狀態Published - 2010 六月 1

All Science Journal Classification (ASJC) codes

  • Energy Engineering and Power Technology
  • Industrial and Manufacturing Engineering

指紋 深入研究「3-D temperature and stress distributions of strip in preheating furnace of continuous annealing line」主題。共同形成了獨特的指紋。

  • 引用此