A manifold design problem for a plate-fin microdevice to maximize the flow uniformity of system

Cheng Hung Huang, Chun Hsien Wang, Sin Kim

研究成果: Article

10 引文 斯高帕斯(Scopus)

摘要

An optimum design problem to determine the optimum shapes for three-dimensional manifolds of plate-fin microdevice for the best system uniformity of flow ratios is examined in this study. The Levenberg-Marquardt Method (LMM) and a general purpose commercial code CFD-ACE+ are utilized to minimize both the system non-uniformity and manifold areas of the microdevice. Two third-order-polynomial functions are used to simulate the boundary shapes for inlet and outlet manifolds, and four different optimization design problems are examined to demonstrate the validity of the present study. The results obtained from the LMM are justified based on numerical experiments, and when applying two third-order-polynomial functions to construct the shapes of manifolds, the designed plate-fin microdevice always has better system uniformity than the design with linear lines in constructing the shapes of manifolds since a 12.08% improvement for the system non-uniformity in the present design, Type OPT4, can be achieved when comparing with the previous optimal design, Type B-O609.

原文English
頁(從 - 到)22-34
頁數13
期刊International Journal of Heat and Mass Transfer
95
DOIs
出版狀態Published - 2016 四月

All Science Journal Classification (ASJC) codes

  • Condensed Matter Physics
  • Mechanical Engineering
  • Fluid Flow and Transfer Processes

指紋 深入研究「A manifold design problem for a plate-fin microdevice to maximize the flow uniformity of system」主題。共同形成了獨特的指紋。

  • 引用此