Calibration of residual stress measurements obtained from EDM hole drilling method using physical material properties

研究成果: Article同行評審

7 引文 斯高帕斯(Scopus)

摘要

When using the electrodischarge machining (EDM) hole drilling method to measure residual stress, the stress induced by the metallurgical transformation layer formed during the drilling process can lead to significant measurement errors. In this study, it is shown that provided the dielectric fluid retains a high level of purity, the stress induced during the drilling process is determined primarily by the thermal conductivity and carbon equivalent of the specimen. Accordingly, these two material properties are used as the basis of two calibration equations designed to compensate the residual stress measurement obtained using the EDM hole drilling method. It is shown that the calibration equations reduce the discrepancy between the actual simulated residual stress values produced by the prestress loadings and the measured residual stress values to less than 8 MPa. The calibration equations provide a significant improvement in the accuracy of the measurement results obtained using the EDM hole drilling technique.

原文English
頁(從 - 到)1462-1469
頁數8
期刊Materials Science and Technology
24
發行號12
DOIs
出版狀態Published - 2008 12月

All Science Journal Classification (ASJC) codes

  • 一般材料科學
  • 凝聚態物理學
  • 材料力學
  • 機械工業

指紋

深入研究「Calibration of residual stress measurements obtained from EDM hole drilling method using physical material properties」主題。共同形成了獨特的指紋。

引用此