Design of frequency-to-voltage converter using successive-approximation technique

Chin E. Lin, An Sang Hou

研究成果: Paper

9 引文 斯高帕斯(Scopus)

摘要

In this paper, the current conveyors, up-down counter, and ultrahigh-speed D/A converter are employed to achieve the fast frequency-to-voltage converter (FVC). Based on the successive-approximation technique, the proposed FVC has short overall response time and does not require any matched components. The transient variations of input signal frequency can be detected. The output voltage is inversely proportional to the input signal frequency. The input signal frequency range from 50 Hz to 2 MHz is tested. The output ripple voltage is verified so little that no low-pass filter is needed. The experimental results demonstrate the static and dynamic characteristics of proposed FVC.

原文English
頁面1438-1443
頁數6
出版狀態Published - 2003 七月 14
事件Proceedings of the 20th IEEE Information and Measurement Technology Conference - Vail, CO, United States
持續時間: 2003 五月 202003 五月 22

Other

OtherProceedings of the 20th IEEE Information and Measurement Technology Conference
國家United States
城市Vail, CO
期間03-05-2003-05-22

    指紋

All Science Journal Classification (ASJC) codes

  • Electrical and Electronic Engineering

引用此

Lin, C. E., & Hou, A. S. (2003). Design of frequency-to-voltage converter using successive-approximation technique. 1438-1443. 論文發表於 Proceedings of the 20th IEEE Information and Measurement Technology Conference, Vail, CO, United States.