Effect of a vertical guide plate on the wind loading of an inclined flat plate

Kung Ming Chung, Chin Cheng Chou, Keh Chin Chang, Yi Jun Chen

研究成果: Article同行評審

5 引文 斯高帕斯(Scopus)

摘要

Wind tunnel experiments were performed to study the wind loads on an inclined flat plate with and without a guide plate. Highly turbulent flow, which corresponded to free-stream turbulence intensity on the flat roof of low-rise buildings, was produced by a turbulence generation grid at the inlet of the test section. The test model could represent a typical solar collector panel of a solar water heater. There are up-stream movements of the separation bubble and side-edge vortices, more intense fluctuating pressure and a higher bending moment in the turbulent flow. A guide plate would result in higher lift coefficient, particularly with an increased projected area ratio of a guide plate to an inclined flat plate. The value of lift coefficient is considerably lower with increased free-stream turbulent intensity.

原文English
頁(從 - 到)537-552
頁數16
期刊Wind and Structures, An International Journal
17
發行號5
DOIs
出版狀態Published - 2013 11月 1

All Science Journal Classification (ASJC) codes

  • 土木與結構工程
  • 建築與營造
  • 建模與模擬

指紋

深入研究「Effect of a vertical guide plate on the wind loading of an inclined flat plate」主題。共同形成了獨特的指紋。

引用此