Erosion of A356.2 alloy by SiO2 particles

J. W. Liou, L. H. Chen, Truan-Sheng Lui

研究成果: Article同行評審

2 引文 斯高帕斯(Scopus)

摘要

Automatic moulding has been widely applied in the casting industry, but erosive wear of moulding dies occurs when being filled with SiO2 sand. A356 alloys have often been used as the die material although their erosion behaviours are still unclear. In this investigation, SiO2 sand erosion of A356.2 alloy in the as-cast, naturally aged and artificially aged conditions was studied by varying the impact angle and choosing two pressures (0.15 and 0.3 MPa) of compressed air to carry the sand particles. The results indicate typical ductile erosion behaviour in which the maximum erosion rate occurs at oblique impact angles of about 20° to 25°, although both ductile wear mechanisms and brittle cracking of eutectic Si particles are present. Despite the improvement of the mechanical properties, the erosion resistance of the naturally aged specimens is only compatible to that of the ascast specimens, and the artificially aged specimens show the greatest erosion rate at an air pressure of 0.3 MPa. Erosion of the artificially aged specimens also leads to a softening effect by dissolution of the Mg2Si particles.

原文English
頁(從 - 到)337-343
頁數7
期刊International Journal of Cast Metals Research
9
發行號6
DOIs
出版狀態Published - 1997 一月 1

All Science Journal Classification (ASJC) codes

  • Mechanics of Materials
  • Mechanical Engineering
  • Metals and Alloys

指紋 深入研究「Erosion of A356.2 alloy by SiO<sub>2</sub> particles」主題。共同形成了獨特的指紋。

引用此