Fabrication and optical design of a pyramid microstructure for the base of a light guide used in backlight module

Jee Gong Chang, Chien Wei Liu, Wang Long Li, Jian Ming Lu, Yu Bin Fang

研究成果: Article

2 引文 斯高帕斯(Scopus)


We propose a recessed pyramid microstructure (PYM) to be used on the base of the light guide as micro-optical components to replace the conventional diffuser dot made by direct etching on the steel stamper. The PYM is made by microelectromechanical systems technology, which uses a silicon wafer for the original PYM mold, which is replicated on a Ni micromold using the electroforming method. An effective optical design tool is used to find the optimal PYM distribution integrating the random microstructure generation scheme based on the molecular dynamics method into optical commercial software. The scanning electron microscopy images show intact PYMs can be produced on the Si micromold and then replicated fully on the Ni micromold by the electroforming process. An intact PYM on the base of the light guide can then be produced by injection molding, completing the transformation of the Ni micromold for use in the light guide. The luminance measurement of a 2.4-in. backlight module with four LEDs shows an average luminance of 4769 nit with 86.3% uniformity for the PYM on the base of light guide, 10% higher than that of the diffuser dot microstructure.

期刊Journal of Micro/Nanolithography, MEMS, and MOEMS
出版狀態Published - 2010 一月 1


All Science Journal Classification (ASJC) codes

  • Electronic, Optical and Magnetic Materials
  • Atomic and Molecular Physics, and Optics
  • Condensed Matter Physics
  • Mechanical Engineering
  • Electrical and Electronic Engineering