Fracture energies and tensile strength of an EPDM/PP thermoplastic elastomer

Chi Wang, C. I. Chang

研究成果: Article同行評審

40 引文 斯高帕斯(Scopus)


Measurements of the tear strength of EPDM/PP thermoplastic elastomers (EPDM/PP TPEs, Santoprene 201-87) were carried out at various rates and temperatures. In addition, a cutting technique developed recently was adopted to measure the fracture energy in a process where a well-controlled geometry of the crack tip was obtained. Results show that the EPDM/PP TPEs possess a relatively high tear strength of 10.40±0.94 kJ/m2 at room temperature. Furthermore, good tear strength is still preserved, about 1.87±0.38 kJ/m2 at 150 °C, where some PP crystals are melted and start to flow. In contrast, the intrinsic strength of EPDM/PP TPEs determined from a cutting test is varied slightly, 700-1000 J/m2, over a wide range of temperatures and rates. A comparison of the fracture energy measured by tearing and cutting tests is provided and discussed. The energy density per unit volume of EPDM/PP TPEs determined from the cutting test is 9.7 GJ/m3, which is about twice larger than that for the rupture of C-C bonds at room temperature. It is suggested that plastic yielding is a more effective process to enhance the toughness than is simply viscoelastic motion.

頁(從 - 到)1033-1044
期刊Journal of Applied Polymer Science
出版狀態Published - 2000

All Science Journal Classification (ASJC) codes

  • 化學 (全部)
  • 表面、塗料和薄膜
  • 聚合物和塑料
  • 材料化學


深入研究「Fracture energies and tensile strength of an EPDM/PP thermoplastic elastomer」主題。共同形成了獨特的指紋。