Investigations of control surface seals for re-entry vehicles

Patrick H. Dunlap, Bruce M. Steinetz, Donald M. Curry, Jeffrey J. DeMange, H. Kevin Rivers, Su Yuen Hsu

研究成果: Conference contribution

6 引文 斯高帕斯(Scopus)

摘要

Re-entry vehicles generally require some combination of control surfaces (e.g., rudders, body flaps, elevons) to steer or guide the vehicles during re-entry into and through the Earth's atmosphere. Control surface seals are installed between these movable surfaces and stationary portions of the vehicle both along hinge lines and in areas where control surface edges are actuated close to the vehicle body. These seals must operate in high-temperature environments and limit hot gas ingestion and transfer of heat to underlying low-temperature structures to prevent over-temperature of these structures and possible loss of vehicle structural integrity. This paper presents results for thermal analyses and mechanical testing conducted on the baseline seal design for the X-38 rudder/fin. This seal application was chosen as a case study to evaluate a currently available control surface seal design for applications in future re-entry vehicles. A thermal analysis of the rudder/fin seal assembly based on representative heating rates predicted a peak seal temperature of 1900 °F. Seals were heated in a compressed state at this peak temperature to evaluate the effects of temperature exposure. Room temperature compression tests were performed to determine load versus linear compression, preload, contact area, stiffness, and resiliency characteristics for as-received and temperature-exposed seals. For all compression levels that were tested, unit loads and contact pressures for the seals were below the 5 lb/in. and 10 psi limits required to limit the loads on the Shuttle tiles that form the adjacent sealing surface for these seals. The seals survived an ambient temperature 1000 cycle scrub test over sanded Shuttle tile surfaces and were able to disengage and re-engage the edges of the rub surface tiles during scrubbing. Arc jet tests were performed to experimentally determine anticipated seal temperatures for representative flow boundary conditions (pressures and temperatures) under simulated vehicle re-entry conditions. Installation of a single seal in the gap of the test fixture caused a large temperature drop (ΔT = 1710 °F) across the seal location confirming the need for seals in the rudder/fin gap location. The seal acted as an effective thermal barrier limiting heat convection through the seal gap and minimizing temperature increases lowdownstream of the seal to acceptable (< 200 °F) levels.

原文English
主出版物標題38th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
出版狀態Published - 2002 十二月 1
事件38th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit 2002 - Indianapolis, IN, United States
持續時間: 2002 七月 72002 七月 10

出版系列

名字38th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit

Other

Other38th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit 2002
國家/地區United States
城市Indianapolis, IN
期間02-07-0702-07-10

All Science Journal Classification (ASJC) codes

  • 航空工程
  • 控制與系統工程
  • 電氣與電子工程

指紋

深入研究「Investigations of control surface seals for re-entry vehicles」主題。共同形成了獨特的指紋。

引用此