Performance of twin-fluid micro-atomizer with internal mixing mechanisms

Muh Rong Wang, Kun He Yang, Tien-Chu Lin, Che Juey Yang

研究成果: Article同行評審

5 引文 斯高帕斯(Scopus)

摘要

This paper describes the performance of the twin-fluid type micro-atomizer designed with internal-impinging mechanisms. This micro-atomizer is fabricated via MEMS bulk micro-machining processes. It is designed with three micro channels for the liquid and gas supply. The orifice hydraulic diameter of the micro atomizer is 45μm. Results show that the velocity profile of the spray is essentially the jet structure with its peak velocity of 6m/s in the central region of the spray jet. Flow visualization through a microscope shows that the liquid becomes a meniscus over the nozzle outlet for the single-fluid injection if the water flow rate is less than 0.4ml/min. It implies that the effect of the surface tension is stronger than the inertial force under the low flow rate range. The liquid becomes a single stream pattern when the flow rates of the single-fluid injection are increased from 0.4ml/min to 1.0ml/min. However, the liquid becomes the spray flow with a cone angle when the gas flow is supplied to the micro-atomizer even under low gas pressure. For example, at the gas pressure of 2bar, the spray has a cone angle of 40°. This phenomenon could be related to excitation of the helical mode due to the impingement of the gas flow at a higher Reynolds number. It results in the favorable condition for atomization processes. Hence the production of fine spray with Sauter mean diameter of 5μm is achieved by the twin-fluid micro-injection under the gas pressure of 5.0bar and the liquid flow rate of 0.1ml/min, a performance better than the micro atomizers reported in the literature.

原文English
頁(從 - 到)9-18
頁數10
期刊Hangkong Taikong ji Minhang Xuekan/Journal of Aeronautics, Astronautics and Aviation
39 A
發行號1
出版狀態Published - 2007 3月 1

All Science Journal Classification (ASJC) codes

  • 航空工程
  • 空間與行星科學

指紋

深入研究「Performance of twin-fluid micro-atomizer with internal mixing mechanisms」主題。共同形成了獨特的指紋。

引用此