Simulating a mining-triggered rock avalanche using DDA: A case study in Nattai North, Australia

Trong Nhan Do, Jian Hong Wu

研究成果: Article

摘要

This study numerically simulated the failure process of a mining-induced landslide at Nattai North, Australia. Results obtained using Discontinuous Deformation Analysis (DDA) matched the conceptual failure process suggested by local geologists and the observed maximum run-out distance. The maximum velocity of the sliding rocks exceeded 40 m/s. Computational results showed that the slope with inward sub-horizontal bedding planes and sub-vertical discontinuities remained stable if the mining-induced high principle stresses did not fracture the rocks near the slope toe. Failure of the rocks near the toe of the slope was a key causal factor in the subsequent landslide. This paper presents the first numerical simulation of the post-failure behavior of the mining-induced landslide at the Nattai North site. It also represents the first DDA simulation to clarify the chain reaction of a mining-induced landslide and demonstrate its applicability in such investigations.

原文English
文章編號105386
期刊Engineering Geology
264
DOIs
出版狀態Published - 2020 一月

指紋

rock avalanche
Landslides
landslide
Rocks
rock
bedding plane
sliding
simulation
discontinuity
analysis
Computer simulation

All Science Journal Classification (ASJC) codes

  • Geotechnical Engineering and Engineering Geology
  • Geology

引用此文

@article{f334ccb44b464ae2a3f517e3ac6ca3aa,
title = "Simulating a mining-triggered rock avalanche using DDA: A case study in Nattai North, Australia",
abstract = "This study numerically simulated the failure process of a mining-induced landslide at Nattai North, Australia. Results obtained using Discontinuous Deformation Analysis (DDA) matched the conceptual failure process suggested by local geologists and the observed maximum run-out distance. The maximum velocity of the sliding rocks exceeded 40 m/s. Computational results showed that the slope with inward sub-horizontal bedding planes and sub-vertical discontinuities remained stable if the mining-induced high principle stresses did not fracture the rocks near the slope toe. Failure of the rocks near the toe of the slope was a key causal factor in the subsequent landslide. This paper presents the first numerical simulation of the post-failure behavior of the mining-induced landslide at the Nattai North site. It also represents the first DDA simulation to clarify the chain reaction of a mining-induced landslide and demonstrate its applicability in such investigations.",
author = "Do, {Trong Nhan} and Wu, {Jian Hong}",
year = "2020",
month = "1",
doi = "10.1016/j.enggeo.2019.105386",
language = "English",
volume = "264",
journal = "Engineering Geology",
issn = "0013-7952",
publisher = "Elsevier",

}

TY - JOUR

T1 - Simulating a mining-triggered rock avalanche using DDA

T2 - A case study in Nattai North, Australia

AU - Do, Trong Nhan

AU - Wu, Jian Hong

PY - 2020/1

Y1 - 2020/1

N2 - This study numerically simulated the failure process of a mining-induced landslide at Nattai North, Australia. Results obtained using Discontinuous Deformation Analysis (DDA) matched the conceptual failure process suggested by local geologists and the observed maximum run-out distance. The maximum velocity of the sliding rocks exceeded 40 m/s. Computational results showed that the slope with inward sub-horizontal bedding planes and sub-vertical discontinuities remained stable if the mining-induced high principle stresses did not fracture the rocks near the slope toe. Failure of the rocks near the toe of the slope was a key causal factor in the subsequent landslide. This paper presents the first numerical simulation of the post-failure behavior of the mining-induced landslide at the Nattai North site. It also represents the first DDA simulation to clarify the chain reaction of a mining-induced landslide and demonstrate its applicability in such investigations.

AB - This study numerically simulated the failure process of a mining-induced landslide at Nattai North, Australia. Results obtained using Discontinuous Deformation Analysis (DDA) matched the conceptual failure process suggested by local geologists and the observed maximum run-out distance. The maximum velocity of the sliding rocks exceeded 40 m/s. Computational results showed that the slope with inward sub-horizontal bedding planes and sub-vertical discontinuities remained stable if the mining-induced high principle stresses did not fracture the rocks near the slope toe. Failure of the rocks near the toe of the slope was a key causal factor in the subsequent landslide. This paper presents the first numerical simulation of the post-failure behavior of the mining-induced landslide at the Nattai North site. It also represents the first DDA simulation to clarify the chain reaction of a mining-induced landslide and demonstrate its applicability in such investigations.

UR - http://www.scopus.com/inward/record.url?scp=85074449259&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=85074449259&partnerID=8YFLogxK

U2 - 10.1016/j.enggeo.2019.105386

DO - 10.1016/j.enggeo.2019.105386

M3 - Article

AN - SCOPUS:85074449259

VL - 264

JO - Engineering Geology

JF - Engineering Geology

SN - 0013-7952

M1 - 105386

ER -