Study on mold filling behaviors of micro channels in injection molding

J. H. Li, Wen Bin Young

研究成果: Article同行評審

3 引文 斯高帕斯(Scopus)

摘要

Computational simulation model has been used extensively in studying the filling flow in injection molding process. Most of the models are based on the assumption of a no-slip boundary condition and are verified by the experiments of filing flow in macro scale. This study is to investigate the flow behaviors during the micro channel filling of an injection molding process. Flow distances were measured on products from series of short shots to understand the relationship between the injection pressure and flow distance. It was found that cavity size variation due to mold deformation is important in the micro injection molding. By adjusting the cavity size due to mold deformation, the C-Mold simulation provides reasonable results compared to the experimental data for cavity thickness in 150 lm or 200 lm. On the other hand, the simulation will not give accurate prediction of filling flow for a micro cavity that has a depth below 100 lm. The wall slip effect is believed to the major reason and must be considered in the analysis for a cavity size below 100 lm.

原文English
頁(從 - 到)421-427
頁數7
期刊International Polymer Processing
24
發行號5
DOIs
出版狀態Published - 2009

All Science Journal Classification (ASJC) codes

  • 化學工程 (全部)
  • 聚合物和塑料
  • 工業與製造工程
  • 材料化學

指紋

深入研究「Study on mold filling behaviors of micro channels in injection molding」主題。共同形成了獨特的指紋。

引用此